1, radiator radiator installation position as close to the host, the better, the best in the host, radiator installation has the best thermal environment, absorb not to the other equipment outlet, especially the oil gas, outlet can't short circuit and elsewhere on the window (especially the residents window) and equipment, should be 2 m from the ground, installed firmly.
2 respectively, the pipe emissions all need to wear insulating tubes with the same wire cable tie bind together with air conditioning, try to walk straight pipe fixed sample and segmented, thermal insulation pipe and heat pipe line with electrical tape or joint.
3, electrical, emissions all wires, besides using air conditioning cable tie fasten with corrugated hose or go trough wear protection, temperature display wire to wire together as far as possible.
And by host condenser, evaporator, refrigeration system have been suppressed sealed in the factory, so in kaifeng, should have the pressure, to check whether there is leakage, factory copper pipe should be two head seal dust measures, also should pay attention to during the construction of seal at any time, to waterproof and dust into the tube, to host, evaporator, condenser copper pipe connected to the welding method, the interface is strong and beautiful.
Line 5, electrical conductor performance with wire diameter up to par, joint is firm, to protect wear tube is not the province, connected correctly. Wire connector holes into the evaporator, silicone seal, pick light more than 36 v battery need to be ground wire, host in electric cabinet into electricity to three-phase five wire system, must be reliable grounding.
6 installation, temperature sensor probe and temperature display probe wear into the Treasury within the evaporator inlet together, and hung up, frost temperature control board is fixed to the day, probe the other punch into the Treasury within the evaporator inlet, probe into wings in (near) electric heating tube, temperature control and temperature control of frost fixed in a corner of the rolls after the evaporator, seal all wiring.
7, balance the window installation don't in a prominent place and outlet vertical plate, the height of vertical plate upside down 200 mm hole.
8, library board seal all throughout parts of base plate, base plate and sealing parts gap with sealant.